10 Chapter 1 Troubleshooting control panel messages
EN
Approximately 80% of the drum’s life has been consumed.
• Drum replacement will be required in the near future.
The imaging drum has reached the end of its expected life.
• Replace the print drum kit.
An error has occurred in the duplex unit.
1 Verify that the duplex unit is correctly installed.
2 Verify that the small power cord from the duplex unit is plugged into
the printer and the power cord from the AC outlet is plugged into the
duplex unit.
The EIO device in slot “x” is initializing. The yyy value will increment
every 10 seconds during this process.
• No action is required.
The EIO slot specified does not have a card installed or is not
functional.
• No action is required.
Drum life low replace drum kit
Drum life out replace drum kit
Duplexer error check duplexer
EIO x initializing yyy
alternates with
Do not power off
EIO x not functional
To Next Page
Loading...