C7085-90921 Chapter 3 Installation and configuration 65
Connecting to a 10Base2 network (J3111A
only)
1 Attach one section of your ThinLAN cable to the BNC “T” connector.
2 Attach another ThinLAN cable section ([1]) or a 50-ohm terminator
([2]) to the other side of the BNC “T” connector. If you are
attaching the printer to the end of your network, you must connect a
50-ohm terminator.)
Note
The BNC “T” connector and 50-ohm terminator for the 10Base-2
connection are not included with the printer. They must be purchased
separately.
3 Connect the BNC “T” connector to the BNC port on the HP JetDirect
print server.
Note
The HP JetDirect J3111A print server supports one Ethernet cable
connection at a time.
BNC port
1
2
3
To Next Page
Loading...