EN Control panel messages 13
1
CONTINUOUS PAGE PRESS CANCEL JOB (4500)
The printer configuration page is being printed continuously.
l Press [Cancel Job] to terminate continuous configuration page
printing and return the printer to the
READY state.
Note
The HP LaserJet 4550 Paper Path test runs from the Information
Menu.
DATA RECEIVED
The printer has received and processed data and is waiting for a form
feed.
l Press [Cancel Job] and resend the last page of the job making
sure a form feed is sent with it, or press Go to feed a new sheet of
media through the printer.
DENSITY SENSOR OUT OF RANGE
alternates with
CLEAN DENSITY SENSOR
A density sensor out of range error was detected during a color
calibration.
l The density sensor might be dirty. Inspect and clean the sensor.
DIAGNOSTICS MODE
The extended diagnostics power-up key sequence has been entered.
Refer to the diagnostics procedures at the end of this chapter.
l No action is required.
DRUM ERROR REPLACE DRUM KIT
An error has been detected with a component of the printer drum kit.
l Replace the drum kit.
www.GovTechMedia.com
To Next Page
Loading...