Incorrect printer output
The following table lists common printer output problems and suggested solutions for
resolving them.
Incorrect printer output
Issue Cause Solution
The font has not been correctly
selected in the software
application.
Re-select the font in the
software applicat ion.
The font is not available to the
printer
Download the font to the
printerorus
e another font. (In
Windows, the driver does this
automatically.)
Incorrect fonts are printed
The correct printer driver is not
selected.
Select the correct printer driver.
The correct font is not selected. Select the correct font.
The correct symbol set is not
selected.
Select the correct symbol set.
Unable to print all characters in
a symbol set
The sele cted character or
symbol is not supported by the
software
application.
Use a font that supports the
selected character or symbol.
Drifting text between printouts Your software appli c ation is not
resettingtheprintertothetopof
the page.
See the docu mentation f or
the software or the PCL/PJL
Technical Reference Package
for specific informati on.
The interface cable is of poor
quality.
Try using a different, higher
quality IEEE-compliant cable.
Parallel cables can be no longer
than 10 meters (30 fe et).
The interface cable is loose. Disconnect and reconnect the
interface cable.
The interface cable is damaged
or bad.
Try using a different interface
cable.
The power cable is loose. Disconnect and reconnect the
power cable.
You are attempting to print
a PCL job with the printer
configured for PostScript
Emulation.
From the printer control panel,
select the correct printer
personality and then resend the
print job.
Erratic, missing characters or
interrupted printout
You are attempting to print a
PostScript job with the printer
configured for PCL.
From the printer control panel,
select the correct printer
personality and then resend the
print job.
EN_WW Incorrect printer output 174
To Next Page
Loading...
