Service approach
Before performing service
●
Remove all media from the product.
●
Turn off the power using the power switch.
●
Unplug the power cable and interface cable(s).
●
Place the product on an ESD mat (if one is available). If an ESD workstation or mat is not available,
ground yourself by touching the sheet-metal chassis before touching an ESD-sensitive part.
●
Remove the print cartridges. See
Print cartridges on page 111.
●
Remove the Tray 1 cassette.
After performing service
●
Plug in the power cable.
●
Reinstall the print cartridges.
●
Reinstall the Tray 1 cassette.
108 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...