Parts removal order
Use the following diagram to determine which parts must be removed before removing other parts.
Figure 6-2 Parts-removal tree
Right cover
Control panel (base model)
Print cartridges
Pickup roller
Separation roller
Front door and front-lower cover door
Left cover
Front-right cover
Rear-upper cover
Rear door and rear-lower cover
ITB
Main motor
Fuser motor
Formatter
Top Cover
Power supply (LV)
Power supply (fuser)
DC controller
Power supply (high voltage)
Fuser
Control-panel overlay (base model)
Control-panel bezel (fax/memory-card models)
Control panel (fax/memory-card models)
Transfer roller
Paper-guide assembly
Print-cartridge drawer
Rear-side cover
ADF/scanner
or scanner assembly
Power supply (HV)
Speaker (fax/memory card models)
Card cover or
blanking cover
ADF pickup-roller assembly
110 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...