3. Disconnect one wire-harness connector (callout 3) and release the wire harness from the retainer
(callout 4).
TIP: it might be easier to release one tab and then remove the retainer from the product chassis.
Figure 6-102 Remove the power supply (low voltage; 2 of 12)
3
4
4. Fax/memory-card models only: Disconnect one FFC (callout 5) and remove it from the retainer
(callout 6).
Figure 6-103 Remove the power supply (low voltage; 3 of 12)
5
6
174 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...