Secondary service menu structure
Table 7-12 Secondary service menu
Menu item Sub-menu item Description
Service Reports Cont. Self-Test This item prints a continuous configuration page.
Extended Keymap (fax/
memory-card models only)
This item prints an extended key map for the alphanumeric keypad on the
control panel.
Error report This item prints an error report.
Scan Calibration Calibrate
Corrected
Tables
Test
This item calibrates the product.
Location A list of available locations
appears
This item sets certain product parameters that are dependent on the
location, such as the default paper size and the symbol set.
Scroll to the appropriate location and select Yes to set the location. The
product automatically restarts after you change the location.
Display test This test verifies that the LEDs and characters on the control-panel display
function correctly.
At the beginning of the test, each of the LEDs is turned on one-at-time.
Press OK to continue to the next LED.
After the LED test is complete, the character test begins by testing the
pixels on each line. Then, each of the 255 characters is displayed in
groups of 16. Press OK to continue to the next group of 16 characters.
You can cancel the test at any time by pressing Cancel
.
Button test This test verifies that the control-panel buttons function correctly. The
display prompts you to press each button.
Show FW Version This item shows the current date code of the firmware.
Ethernet reset (network
models only)
This item resets the ethernet driver. This should be used when the network
is not accessible. This is a low-level, internal reset and does not affect
network settings.
Memory Cards (fax/memory-
card models only)
Enable
Disable
This item enables or disables the product memory-card functions.
Color Cal. Adjust color This item adjusts density settings for contrast, highlights, midtones, and
shadows. Adjust each color individually.
Timing This item specifies how frequently the product should automatically
perform a color calibration. The default setting is 48 hours. You can turn
automatic calibration off.
Clean Belt This item runs additional belt-cleaning cycles.
Pick roller This item puts the pickup roller in position for replacement.
244 Chapter 7 Problem solve ENWW
To Next Page
Loading...