3. Open the rear door, and then remove one screw (callout 3), and then remove the print-cartridge
door stop (callout 4).
Figure 6-76 Remove the ITB (2 of 5)
3
4
4. Carefully lift up on the black plastic portion of the ITB, and then pull it partially out of the product
(the ITB wire harness will prevent the ITB from being fully removed).
WARNING! Only partially pull the ITB out of the product to avoid damage to the secondary-
transfer (T2) roller.
See
Figure 6-79 Remove the ITB (5 of 5) on page 158 to see how to correctly handle the ITB to
prevent damaging it. Do not lift the ITB by grasping the sheet-metal bracket.
CAUTION: Avoid touching the black plastic transfer belt. Skin oils on the belt might cause print-
quality problems.
Figure 6-77 Remove the ITB (3 of 5)
ENWW Internal assemblies 157
To Next Page
Loading...