5. Feed the ITB wire harness (callout 5) through an opening in the chassis (callout 6).
Figure 6-78 Remove the ITB (4 of 5)
5
6
6. Carefully pull the ITB straight out of the product.
WARNING! Handle the ITB by its hard plastic sides to avoid damage to the sheet metal frame.
The lower sheet-metal portion of the ITB frame can be easily bent. See callout 1 in
Figure 6-80
Reinstall the ITB (1 of 2) on page 159.
CAUTION: Make sure that the ITB wire harness does not get damaged as the ITB is removed
from the chassis.
Figure 6-79 Remove the ITB (5 of 5)
158 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...