13. Rotate the end of the power supply near the control-panel module out and away from the product
until it clears the chassis, and then slide the power supply toward the control-panel module to
remove it.
NOTE: As you remove the power supply, feed the wire harness at the rear of the product through
the opening in the chassis.
TIP: Make sure that the tab on the right end of the power-supply chassis fits into the slot on the
product chassis when the power supply is reinstalled.
Figure 6-112 Remove the power supply (low voltage; 12 of 12)
2
1
Reinstall the power supply (low voltage)
When you reinstall the power supply, make sure that the hook on the power supply tray is engaged with
the slot at the back side of the product chassis.
Figure 6-113 Reinstall the power supply (low voltage)
ENWW Internal assemblies 179
To Next Page
Loading...