Power supply (fuser)
CAUTION: Some parts are sensitive to electrostatic discharge (ESD). Look for the ESD
reminder when removing product parts. Always perform service work at an ESD-protected workstation
or mat. If an ESD workstation or mat is not available, ground yourself by touching the sheet-metal chassis
before touching an ESD-sensitive part.
1. Remove the following components:
●
Right cover. See
Right cover on page 132.
●
Left cover. See
Left cover on page 135.
●
Rear-side cover. See
Rear-side cover on page 142.
●
Rear door and rear-lower cover. See
Rear door and rear-lower cover on page 145.
2. Remove two screws (callout 1) and the power-supply cover (callout 2).
Figure 6-114 Remove the power supply (fuser; 1 of 5)
1
2
180 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...