3. Carefully place the product front-side up.
WARNING! Do not place the product face-up resting on the rear cover and rear door. Excess
toner might enter the laser/scanner assembly and contaminate the mirrors, causing print-quality
problems. The laser/scanner is not a FRU. If the laser/scanner mirrors are contaminated, the entire
product must be replaced.
Figure 6-11 Remove the Tray 1 paper-pickup roller (2 of 3)
4. Release two tabs, and then rotate the roller away from the product to remove it.
Figure 6-12 Remove the Tray 1 paper-pickup roller (3 of 3)
ENWW Rollers and pads 91
To Next Page
Loading...