Separation pad (Tray 1)
CAUTION: Avoid touching the pad surface unless you are going to replace the pad. Skin oils on the
pad can cause paper-pickup problems.
1. Remove Tray 2 (if installed).
2. Lower the Tray 1 paper-pickup assembly by pushing down on the edges of the assembly.
Figure 6-13 Remove the Tray 1 separation pad (1 of 2)
3. Release the retainer tabs, and then remove the separation pad from the base.
NOTE: The separation pad base can easily be dislodged when the pad is removed. If the base
is dislodged, do not loose the spring under the base (it is not captive).
Figure 6-14 Remove the Tray 1 separation pad (2 of 2)
92 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...