Rear-door stopper and link caps (simplex product)
1. Open the rear door.
2. Use a pair of needle-nose pliers to release two tabs, and then remove the link cap.
TIP: It might be easier to remove the link caps if you remove the feed assembly. See Paper-feed
guide assembly on page 101.
Figure 6-30 Remove the rear-door stopper and link caps (simplex product) (1 of 2)
3. Use a small, flat-blade screwdriver to carefully remove the remaining link cap, and then remove
the rear-door stopper.
Figure 6-31 Remove the rear-door stopper and link cap (simplex product) (2 of 2)
ENWW Components and major assemblies 103
To Next Page
Loading...