Rear door (simplex product)
1. Open the rear door.
2. Use a pair of needle-nose pliers to release two tabs, and then remove the link cap.
TIP: It might be easier to remove the link cap if you remove the feed assembly. See Paper-feed
guide assembly on page 101.
Figure 6-32 Remove the rear door (simplex product) (1 of 4)
3. Remove four screws (callout 1).
Figure 6-33 Remove the rear door (simplex product) (2 of 4)
1
104 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...