9. Remove three screws (callout 12), and then remove the fuser motor assembly.
Figure 6-123 Remove the fuser motor assembly (8 of 8)
12
Reinstall the fuser motor assembly
Ensure that the fuser motor assembly spring (callout 1) and gear pin (callout 2) are correctly positioned
in the hole and slot provided in the assembly mounting bracket. The assembly mounting bracket fits flat
against the product chassis when the fuser motor assembly is correctly installed.
Figure 6-124 Reinstall the fuser motor assembly
2
1
158 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...