Duplex reverse-drive assembly
1. Remove the following components:
●
Right cover. See
Right cover on page 108.
●
Rear door (simplex products). See
Rear door (simplex product) on page 104.
●
Rear cover (simplex products). See
Rear cover and feed guide (simplex product)
on page 112.
●
Rear-upper cover (duplex products). See
Rear-upper cover (duplex product) on page 111.
●
Rear door (duplex products). See
Rear door (duplex product) on page 106.
●
Rear-lower cover (duplex products). See
Rear-lower cover and rear-door links (duplex
product) on page 116.
●
Upper-cover assembly. See
Upper-cover assembly on page 121.
●
Control-panel assembly. See
Control-panel assembly on page 124.
●
Right panel. See
Right panel on page 136.
2. Disconnect two connectors (callout 1), and then pass the connectors under the rear-door rib
assembly.
Figure 6-125 Remove the duplex reverse-drive assembly (1 of 4)
1
ENWW Components and major assemblies 159
To Next Page
Loading...