3. Lift the Tray 3 pickup assembly (callout 1) slightly to clear a tab (callout 2), and then slide it in the
direction that the arrow indicates to remove it.
Figure 2-115 Remove the Tray 3 pickup assembly (3 of 3)
1
2
Reinstallation tip When reassembling the Tray 3 pickup assembly, be sure to fit the shaft (callout 1)
on the assembly to the hole (callout 2) in the feeder.
2
1
Tray 3 lifter drive assembly
1. Remove the tray from the feeder, and then remove the rear cover (see Tray 3 rear cover
on page 161).
168 Chapter 2 Removal and replacement ENWW
To Next Page
Loading...