2. Disconnect two connectors (callout 1).
Figure 2-116 Remove the Tray 3 lifter drive assembly (1 of 2)
1
3. From the front, inside the tray cavity, remove three screws (callout 1), release one tab (callout 2),
and then remove the Tray 3 lifter drive assembly (callout 3).
Figure 2-117 Remove the Tray 3 lifter drive assembly (2 of 2)
2
3
1
Tray 3 pickup motor
1. Remove the tray from the feeder, and then remove the rear cover (see Tray 3 rear cover
on page 161).
ENWW Removal and replacement procedures 169
To Next Page
Loading...