Intermediate transfer belt (ITB)
CAUTION: Do not touch the black-plastic belt. Skin oils and fingerprints on the belt can cause print-
quality problems. Always place the ITB on a flat surface in a safe and protected location.
1. Open the right-door assembly.
2. Use both hands to grasp the blue levers (callout 1), apply slight downward pressure, and pull the
ITB toward you at a downward angle.
Figure 2-16 Remove the intermediate transfer belt (1 of 3)
1
3. Pull the ITB out of the product until two large handles expand along the right and left side of the
ITB.
Figure 2-17 Remove the intermediate transfer belt (2 of 3)
ENWW Removal and replacement procedures 87
To Next Page
Loading...