To Next Page

To Previous Page

Removal and replacement procedures 4–1

Removal and replacement procedures

Preliminary replacement requirements

Tools required

You will need the following tools to complete the removal and replacement procedures:

■ Flat-bladed screwdriver

■ Magnetic screwdriver

■ Phillips P0 and P1 screwdrivers

■ Torx T8 screwdriver

Service considerations

The following sections include some of the considerations that you must keep in mind during disassembly and

assembly procedures.

✎

As you remove each subassembly from the computer, place the subassembly (and all accompanying screws)

away from the work area to prevent damage.

Plastic parts

CAUTION: Using excessive force during disassembly and reassembly can damage plastic parts. Use care when handling the

plastic parts. Apply pressure only at the points designated in the maintenance instructions.

Cables and connectors

CAUTION: When servicing the computer, be sure that cables are placed in their proper locations during the reassembly

process. Improper cable placement can damage the computer.

Cables must be handled with extreme care to avoid damage. Apply only the tension required to unseat or seat the

cables during removal and insertion. Handle cables by the connector whenever possible. In all cases, avoid

bending, twisting, or tearing cables. Be sure that cables are routed in such a way that they cannot be caught or

snagged by parts being removed or replaced. Handle flex cables with extreme care; these cables tear easily.

Other manuals for HP Compaq 2230s

Questions and Answers:

Need help?

Do you have a question about the HP Compaq 2230s and is the answer not in the manual?

General