HP Compaq 2230s

Computer Setup 5–4
System Configuration menu
✎
Some of the listed System Configuration options in this section may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot Options ■ Set a Startup Menu delay (in seconds).
■ Enable/disable Custom Logo (disabled by default).
■ Enable/disable Display Diagnostic URL (enabled by default).
■ Enable/disable CD-ROM boot (enabled by default).
■ Enable/disable SD Card boot (enabled by default).
■ Enable/disable floppy boot (enabled by default).
■ Enable/disable PXE Internal NIC boot (enabled by default).
■ Set the Express Boot Popup delay in seconds.
■ Set the boot order.
Device Configurations ■ Enable/disable USB legacy support (enabled by default). When enabled,
USB legacy support allows the following:
❐ Use of a USB keyboard in Computer Setup even when a Windows®
operating system is not running.
❐ Startup from bootable USB devices, including a hard drive, diskette drive,
or optical drive connected by a USB port to the computer.
■ Select a parallel port mode: ECP (Enhanced Capabilities Port), standard,
bidirectional, or EPP (Enhanced Parallel Port).
■ Enable/disable fan always on while connected to an AC outlet (enabled
by default).
■ Enable/disable LAN Power Save (select models only). When enabled, saves
power by turning off the LAN when not in use (enabled by default).
■ Enable/disable Data Execution Prevention. When enabled, the processor can
disable some virus code execution, which helps to improve computer security.
■ SATA (Serial Advanced Technology Attachment) device mode. The following
options are available:
❐ AHCI (Advanced Host Controller Interface)
❐ IDE (Integrated Drive Electronics)
❐ RAID (select models only)
✎
Availability of the options above varies by computer model.
■ Enable/disable secondary battery fast charge (enabled by default).
■ Enable/disable HP QuickLook 2 (enabled by default).
■ Enable/disable Virtualization Technology (select models only; disabled
by default).
■ Enable/disable TXT (Intel® Trusted Execution Technology) (select models
only; disabled by default).
■ Enable/disable Dual Core CPU (select models only; enabled by default).
■ Enable/Disable Unified Extensible Firmware Interface (UEFI) mode (disabled
by default).
(Continued)