EasyManuals Logo

HP COMPAQ 8000 User Manual

HP COMPAQ 8000
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
Installing and Removing a Port Cover
An optional rear port cover is available for the computer.
To install the port cover:
1. Thread the cables through the bottom hole on the port cover (1) and connect the cables to the rear
ports on the computer.
2. Insert the hooks on the port cover into the slots on the rear of the chassis, then slide the cover to
the right to secure it in place (2).
Figure 2-21 Installing a Port Cover
NOTE: For security purposes, you can install an optional cable lock to the chassis that locks the port
cover and secures the computer. See
Installing a Security Lock on page 32.
The port cover is secured in place by a retention lever just inside the port cover opening. To remove the
port cover, pull the lever back towards the port cover opening (1), then slide the cover to the left and off
the computer (2).
Figure 2-22 Removing a Port Cover
26 Chapter 2 Hardware Upgrades ENWW

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP COMPAQ 8000 and is the answer not in the manual?

HP COMPAQ 8000 Specifications

General IconGeneral
ChipsetIntel Q45 Express
AudioIntegrated High Definition audio
ProcessorIntel Core 2 Duo
RAMUp to 16 GB DDR3
StorageHDD or SSD
GraphicsIntegrated Intel Graphics Media Accelerator
Operating SystemWindows 7, Windows Vista, Windows XP
NetworkIntegrated Gigabit Ethernet
Ports1 VGA, 1 DisplayPort, 1 serial, audio in/out
Optical DriveDVD-ROM
Form FactorSmall Form Factor
Expansion Slots1 PCI, 2 PCIe x1, 1 PCIe x16

Related product manuals