EasyManuals Logo

HP Compaq LA2205wg User Manual

HP Compaq LA2205wg
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Removing the Monitor Pedestal Base
You can remove the monitor panel from the pedestal base to install the panel on a wall, a swing arm,
or other mounting fixture.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the
power and signal cables are both disconnected. Also disconnect all USB cables connected to the
monitor.
1. Disconnect and remove the signal, power, and USB cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then
pivot the base 45 degrees counter-clockwise and remove the other screw from the back of the
monitor.
Figure 2-9 Removing the Pedestal Base Screws
4. Rotate the base of the monitor up (1) then pull it back (2) to unhinge the tabs on the monitor
stand from the slots in the monitor.
Figure 2-10 Removing the Pedestal Base
Removing the Monitor Pedestal Base 11

Other manuals for HP Compaq LA2205wg

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq LA2205wg and is the answer not in the manual?

HP Compaq LA2205wg Specifications

General IconGeneral
3DNo
Pixel pitch0.282 x 0.282 mm
Display diagonal22 \
Separate H/V syncYes
Display resolution1680 x 1050 pixels
Contrast ratio (dynamic)3000:1
Contrast ratio (typical)1000:1
Display number of colors-
Viewing angle, horizontal160 °
Digital vertical frequency50 - 76 Hz
Digital horizontal frequency24 - 83 kHz
Display brightness (typical)250 cd/m²
Supported graphics resolutions1280 x 960, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1440 x 900 (WXGA+), 1680 x 1050 (WSXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
USB hub version2.0
DVI-I ports quantity0
USB Type-A downstream ports quantity2
LED indicatorsPower
Tilt angle range-5 - 30 °
Height adjustment120 mm
Panel mounting interface- mm
On Screen Display (OSD) languagesCHI (SIMPL), CHI (TR), DEU, DUT, ENG, ESP, FRE, ITA, JPN, POR
AC input voltage100 - 240 V
Power consumption (off)0.5 W
Power consumption (standby)1 W
Power consumption (typical)33 W
Power requirements100 - 240V, 47/63Hz
Sync input impedance75 Ω
Operating altitude0 - 5000 m
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)5 - 95 %
Operating relative humidity (H-H)20 - 80 %
Package depth231 mm
Package width591 mm
Package height492 mm
CertificationEPEAT Gold, RoHS
Country of originChina
Market positioningBusiness
Sustainability certificatesENERGY STAR
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)254.9 mm
Width (with stand)511.2 mm
Height (with stand)373.5 mm
Depth (without stand)62 mm
Width (without stand)511 mm
Height (without stand)334 mm
Weight (without stand)6820 g

Related product manuals