Power/battery pass-through board
Description Spare part number
Power/battery pass-through board
For use on the following model numbers only: HP: 110-1000 — 110-1099 and Compaq: 110c-1000
— 110-1099
537615-001
For use on the following model numbers only: HP: 110-1100 — 110-1199 and Compaq: 110c-1100
— 110-1199
581326-001
Before removing the power/battery pass-through board, follow these steps:
1. Shut down the device. If you are unsure whether the device is off or in Hibernation, turn the device
on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the device.
3. Disconnect the power from the device by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the device.
4. Remove the battery (see
Battery on page 44).
5. If your device has WWAN capability, remove the SIM (see
SIM on page 45).
6. Remove the following components:
a. Keyboard (see
Keyboard on page 48)
b. Hard drive or solid-state drive (see
Mass storage devices on page 54)
c. Top cover (see
Top cover on page 57)
Remove the power/battery pass-through board:
1. Disconnect the power cable (1).
2. Remove the 2 Phillips BP2.5×5.0 screws (2) that secure the power/battery pass-through board to
the base enclosure.
66 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General
