Removal and Replacement Procedures
Maintenance and Service Guide 5–39
2. Disconnect the SD Card slot board cable 1 from the system
board.
3. Remove the PM2.5×5.0 screw 2 that secures the SD Card
slot board to the notebook.
4. Remove the PM2.5×5.0 screw 3 that secures the SD Card
slot board cable ground loop to the notebook.
5. Remove the SD Card slot board and cable.
Removing the SD Card Slot Board and Cable
Reverse the above procedure to install the SD Card slot board
and cable.
325388-002.book Page 39 Friday, October 24, 2003 9:21 AM
To Next Page
Loading...
