Removal and Replacement Procedures
Maintenance and Service Guide 5–41
2. Remove the PM2.5×15.0 1 and PM2.0×3.0 2 screws that
secure the VGA board shield to the base enclosure.
3. Lift the upper left corner of the VGA board 3 to disconnect
it from the system board.
4. Remove the VGA board and shield 4.
5. Disengage the shield clips 5 to remove the VGA board from
the shield.
Removing the VGA Board and Shield
325388-002.book Page 41 Friday, October 24, 2003 9:21 AM
To Next Page
Loading...
