Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany
The official EU CE declaration of conformity for this device may be found at http://www.hp.com/go/
certificates.
HP products which bear the “GS” approval mark, when forming part of a system comprising HP
computers, keyboards and monitors that bear the “GS” approval mark, meet the applicable ergono
requirements. The installation guides included with the products provide configuration information.
Power Cord Set Requirements
The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows
monitor to operate on input voltages between 100–120V or 200–240V.
The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use
in the country where you purchased the equipment.
If you need to obtain a power cord for a different country, you should purchase a power cord that is
approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage an
current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimu
of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m)
If you have questions about the type of power cord to use, contact an authorized HP service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon
it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where
cord exits from the product.
31
Appendix C Agency Regulatory Notices
ENWW
To Next Page
Loading...
Need help?
General
