The Properties section contains a window for previewing the selected job in the queue and viewing
additional information.
Collate copies
1. Press the Print tab.
2. Press the Add to List button.
3. Using the check boxes, select multiple files for printing.
4. Press the Number of Sets button and select the number of copies you wish to print.
5. Press the Print button.
The files that you selected form a set, which is printed the number of times that you selected.
Clean the glass
1. Turn the scanner power off and disconnect the scanner power cable.
2. Push down on the two lever buttons found near the insertion slot on each side of the scanning area
lid. The scanning area lid locking mechanism should now be disengaged.
3. As you hold both lever buttons down, place your free fingers in the insertion slot and flip the
scanning area lid open. The scanning area is now exposed for cleaning.
4. Gently wipe the glass plate with a lint-free cloth dampened with a mild, streak-free, glass cleaner.
CAUTION Do not use abrasives, acetone, benzene, or fluids that contain these
chemicals. Do not spray liquids directly onto the scanner's glass plate or anywhere else
in the scanner.
The lifespan of the glass plate depends on the paper types that pass across it. Abrasive
papers such as mylar may cause premature deterioration, in which case the replacement
of the plate is the customer's responsibility.
5. Dry the glass completely using a separate clean, dry lint-free cloth like the one provided with the
maintenance kit.
Set sleep and wake-up timers
1. Press the Setup tab.
2. Press the Options button.
3. Press the System button.
ENWW Collate copies 115
How do I... (scanner topics)
[4500]
To Next Page
Loading...
