A printhead cleaner status message
These are the possible printhead cleaner status messages:
● OK: the cleaner is working normally, with no known problems
● Missing: there is no cleaner present, or it is not properly installed in the printer
●
Reseat cleaner: you are recommended to remove the cleaner and then reinsert it
● Wrong stall: the cleaner has been installed in the wrong place
● End of life: the cleaner has reached the end of its planned lifetime
●
Not replaced with printhead: you have installed a new printhead without installing the new
cleaner that came with it
If a printhead cleaner needs to be removed or reseated, you must start the printhead replacement
process (see
Remove a printhead). Open the window when prompted to do so by the front panel. If the
front panel shows the printheads with no printhead blinking, you do not need to touch the printheads.
Just close the window again, and the printer will proceed to printhead cleaner replacement.
162 Chapter 15 The problem is... (ink system topics) ENWW
The problem is... (ink system
topics)
To Next Page
Loading...
