HP Designjet 4000 Series

Roll detached from spindle
If the end of the roll is visible but no longer attached to the spindle:
1. If you have already selected Paper unload at the front panel, press the Cancel key to cancel that
procedure.
2. Lift the paper load lever. If the front panel displays a warning about the lever, ignore it.
3. Pull out the paper from the front of the printer.
4. Press the spindle lever down and remove the empty spindle from the printer, pulling out the right-
hand end first. Do not insert your fingers into the spindle supports during the removal process.
5. Lower the paper load lever.
6. If the front panel is displaying a warning message, press the Select key to clear it.
No paper visible
If the end of the roll has entirely disappeared into the printer:
1. Press the Form Feed and Cut key on the front panel, and the remaining paper will be ejected.
2. Press the spindle lever down and remove the empty spindle from the printer, pulling out the right-
hand end first. Do not insert your fingers into the spindle supports during the removal process.
Load a single sheet [4000]
NOTE This topic applies to the HP Designjet 4000 Printer series only.
Any loaded roll must be unloaded before loading a sheet. See Unload a roll from the printer [4000].
1.
At the printer's front panel, select the
icon, then Paper load > Load sheet.
NOTE As usual, you must press the Select key to select this option.
ENWW Load a single sheet [4000] 25
How do I... (paper topics)