The calibration process in detail
1. Load the printer with the type of paper that you plan to use for printing
subsequently. The paper must be at least 41 cm wide (16 in) and 75 cm long (30
in).
2.
Select the
or icon, and then Paper advance calibration.
3. Select Drawings/text or Images, depending on the type of prints you wish to
make subsequently.
Note It is very important to use the same setting that you will later use
for printing in the driver, the Embedded Web Server, or the front panel
(Optimized for drawings/text or Optimized for images). Otherwise the
calibration has no effect.
4. Select Print Patterns. The printer will print a series of numbered patterns (1 to
7), each looking like this if you selected Drawings/text:
or like this if you selected Images:
5. The Drawings/text print takes about three minutes, the Images print takes about
five minutes. When the calibration print has finished printing, the printer will cut
the paper.
Chapter 12
184
How do I perform paper advance
calibration?
To Next Page
Loading...
