Not for resale
© 2004 Hewlett-Packard Company
Made in
Disk only: QXXXX-XXXXX
Setup instructions
HP Designjet 4000 and 4000ps Printers
Read these instructions carefully...
1 Preliminary unpackingPrinter working area
What you will need for this procedure
Because some of the components of the printer
are bulky, you will need up to four people to lift
them. When this is necessary, this symbol is
displayed:
To assemble the printer you will need at least
3 × 5 m (10 × 16 ft) of empty floor space, and
about two hours.
Before you start unpacking, consider where you are going to put the assembled
printer. You should allow some clear space at the back and at the front of
the printer. The recommended clearances are shown in the illustration below.
Cut the strap around the boxes carefully, as the
boxes may fall as soon as the strap is cut.
Mark on box Contents of box
Printer body
Stand and bin assembly
Consumables box, including…
Maintenance Kit (please keep this safe)
Spare box (used in Section 3 of these
setup instructions)
1
The shapes on the boxes identify the contents. Refer to the table below:
In case of difficulty,
please consult:
Your printer’s Embedded Web Server
Using your printer
CD
Main printer
box
Strap
Remove the two side lids. Then remove all the upper four
plastic handles from both sides of the box (2 each side).
To Next Page
Need help?
General
