1–9
Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open
This is the blue on page 1–9 (seq: 25)
This is the black on page 1–9 (seq: 25)
Task 4: Switch on
Be sure that the power cord supplied with your printer matches your ac
power connection requirements. Use only three-wire (earth-grounded) power
cords with this printer.
1 Make sure that the power switch on the front of the printer is in the OFF position
(extended).
on
off
2 Plug the power cord into the socket at the back of the printer, and then into your
power outlet.
3 Switch on the printer, by pushing the power switch.
After you switch on, the printer will execute a self diagnostic test while flashing
each of the lights for a few moments. The lights will stop and you will be ready
for the next step.
4 If there is no sound, nor any light on the front panel, you may have a power
problem. For troubleshooting information, see Chapter 9.
Localization Note.
SETUP
1
Setting up your printer
Task 4: Switch on
WARNING
To Next Page
Loading...