1–13
Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open
This is the blue on page 1–13 (seq: 29)
This is the black on page 1–13 (seq: 29)
4 When all the cartridges are installed, lower the cover. On the front panel, the
Ready light should flash for up to about a minute and then go off. The Load
Media
light should then be on (together with Media Type and Print Quality lights).
5 If you wish, you can now check your cartridge alignment by running the Black
Cartridge Alignment Routine (see page 5–4). However, this is normally only
required for troubleshooting.
Localization Note.
SETUP
1
Setting up your printer
Task 5: Load the print cartridge(s)
This is the green on page 1–13
(seq: 29)
READY
LOAD MEDIA
Print Quality
lights
lights
Media Type
To Next Page
Loading...