HP Designjet 430 - To cut and unload a print from a roll

2–27
Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open
This is the blue on page 2–27 (seq: 69)
This is the black on page 2–27 (seq: 69)
To cut and unload a print from a roll
When the print is finished, the Ready light stops flashing and goes off.
Your printer includes a built-in cutter. The cutter automatically cuts the roll
between prints, unless you have disabled it through software or the setup sheet.
While the cutter is operating, keep your fingers away from the media entry
slot.
If the cutter has been disabled through software and you want to cut the roll:
1 Before cutting the roll, make sure that no other print has been sent to the printer.
2 Press the
Form Feed key. This activates the cutter.
MEDIA
2
Working with media
Unloading media
Localization Note.
CAUTION
READY
FORM FEED