Remove all the upper four plastic handles from both sides of
the box (two each side). Carefully fold the two side lids
up onto the top of the box as shown, then remove the two
boxes.
Remove the 2 lids. Place the consumables and spare boxes
in front of the printer body. Then lower the stand and bin box
onto the consumables and spare boxes.
Lower the roll module box onto the consumables and
spare boxes. Then lower the roll module box onto the
floor. Then remove the consumables and spare boxes.
2
1
1
3
Preliminary unpacking
Outside Europe
The shapes on the boxes identify the contents.
Preliminary unpacking
Europe
Mark on box Contents of box
Printer body
Stand and bin assembly
Roll module
Consumables box, including…
Maintenance Kit (please keep this safe)
Spare box (used on page I and J of these
setup instructions)
Scanner stand (mfp only)
Scanner body (mfp only)
B
Remove all eight plastic handles from both sides
of the box.
Remove the main printer box.
54 6 7
98 10 11
To Next Page
Loading...
