8-194
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
13. Lift up the Roll 2 Module from below, this is
to release the top of the assembly from the
two Load Bearing Pin Screws located at the
top of both legs at the rear.
14. When the Roll 2 Module has been lifted off
the two Load Bearing Pin Screws, from the
front of the printer, tilt the top of the
assembly slightly away from you.
15. When the Roll 2 Module is clear of the
pins you will be able to move the assembly
down.
To Next Page
Loading...
