HP Designjet 4500 - Page 493

8-193
Removal and Installation
HP Designjet 4500 Printer Series Service Manual
10. Remove two T20 screws that secure the left
side of the Roll 2 Module to the Printer.
The screws used to secure the left
side of the Roll 2 Module are
different from the screws that
secure the right side.
11. Remove a locking screw which locks the
left side of the Roll 2 Module in place.
12. Slightly pull out the Roll 1 Drawer.
Warning: The next steps should be
performed by a minimum of two
people, one at the front and one
at the rear. There is a risk of injury
as the Roll 2 Module is very
heavy.