Media misaligned.
1_ Lift lever
2_ Align Media with
both edges of roll
3_ Lower lever
A roll has been loaded
incorrectly.
For an animation of the
roll loading procedure,
see
loading rolls into the
printer. Remember to
align the printing
material coming out of
the printer with the edge
of the roll. Do not align it
with the blue marks on
the printer.
Media misaligned.
1_ Lift lever
2_ Align right edge
with blue line
3_ Lower lever
A sheet has been loaded
incorrectly.
See
how do I load
sheets?.
Media mispositioned.
1_ Lift lever
2_ Correct position
3_ Lower lever
The roll is mis-positioned in
the printer. This may mean
it is too far to the left on
the platen.
For guidelines on loading
rolls, see
loading rolls
into the printer.
Remember to align the
printing material coming
out of the printer with
the edge of the roll. Do
not align it with the blue
marks on the printer.
Media too small The printing material you
are attempting to load is
too small for the printer to
print the file.
In the case of an internal
calibration, remember to
use at least a D-sized
printing material.
Misalignment This means that the
printing material has not
been fed into the printer
straight.
Reload the printing
material, making sure
that the edges are
parallel and that it is
straight when you feed it
in. Align the material
coming out from the
printer with the material
going into the printer.
See
loading rolls into the
printer.
Misposition The printing material is not
positioned correctly in the
printer. It may be too far
to the left or the right.
Check that you have
loaded the printing
material correctly as
shown in the procedure
loading rolls into the
printer.
No media profile
available
The printer cannot find the
internal media profile.
Unload any printing
material in the printer
and switch the printer off
using the switch at the
back. Switch on again. If
the problem persists, call
your HP representative.
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0151.htm (4 of 8) [8/5/2002 4:23:08 PM]
To Next Page
Loading...