HP DesignJet 5500 - Page 135

tell me about front-panel messages
OK The ink system is working
correctly
None
Preparing printheads Your printer is servicing
the printheads to maintain
optimum print quality.
See
preparing
printheads.
Preventative
maintenance advised
The printer has kept track
of the number of cycles
your printer has
performed. This message
means the printer needs
maintenance to maintain
its performance and to
prevent printer down-time
in the future.
Contact your local HP
representative. Arrange a
time that would be
convenient for you, and
he will service the
printer. See
service
preventative
maintenance.
Printer temperature is
out of the printer's
operating range.
Printer cannot
function.
Under cold environmental
conditions outside its
operating range the printer
will stop. It does this to
protect the ink systems
inside the printer.
Simply ensure the
temperature is above
15°C and turn the printer
off and on again.
Printing Low memory The printer previously
compressed a print file
while receiving it, and it is
now expanding the file.
Printing will continue
after expanding the data,
but it will be slower than
usual.
Processing The printer has received a
print file and is processing
the information before
starting to print.
Receiving The printer is receiving a
file.
If you have problems
printing, see
the problem
is ...
Receiving Low
memory
While receiving a print file,
the printer's memory has
become low.
The printer will compress
the file while it continues
to receive the data.
XXXX Recover There is a problem with
one of the printheads you
are using. To see which
printhead has the problem,
go to the printhead menu
and press Enter.
See
printhead error
messages.
Remove ink cartridge
by pushing it in and
up
This is an ink cartridge
removal instruction.
For an animation showing
the cartridge removal
procedure, see
how do I
remove ink cartridges?.
Remove media weight
Wind excess media
using TUR button
Press ENTER
When you are unloading a
roll from the printer, you
must remove the media
weight from the take-up
reel before you can
complete the procedure.
If you do not want to use
the take-up reel, you can
turn off the setting by
going to Utilities > TUR
installed > No.
XXXX Replace A printhead needs to be
replaced.
See
printhead error
messages.
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0151.htm (5 of 8) [8/5/2002 4:23:08 PM]