Replace cleaner The printer is designed so
that when you replace a
printhead you must also
replace the printhead
cleaner. See
component
identification for the
location.
See
how do I remove
printhead cleaners for an
animation of this
procedure.
Replace ink cartridge This is an ink cartridge
removal instruction.
For an animation of the
cartridge removal
procedure, see
how do I
remove ink cartridges?.
Reset Web Passwd When this is displayed you
are resetting your
WebAccess password. See
tell me about webaccess.
Setup The setup message is
displayed when new tubes
have been installed into
the printer and you have
installed the correct setup
printheads.
When the setting-up of
the tube system is
complete, the front panel
will display a message
asking you to remove the
setup printheads and
replace them with
`normal printheads'.
Sheet misaligned. Lift
lever to align with
blue line or to remove
media.
The printing material has
not been fed into the
printer straight.
Reload the printing
material making sure that
the edges are parallel
and that it is straight
when you feed it in. Align
the material coming out
of the printer with the
material going into the
printer. See
how do I
load sheets?
Sheet required for
calibration
The printer is prompting
you to load printing
material (at least D-sized)
so that it can perform a
calibration.
For an animation on the
loading procedure, see
how do I load sheets?
Switch power off
Check media path
There is a media jam in the
printer.
clearing a media jam
Switch power off
Check printhead path
There is a media jam in the
printer.
Switch the printer off and
clear the blockage.
See
clearing a media
jam.
Switch power off
Restart printer
startup with all ink
cartridges
The ink system startup
must have full cartridges
installed to enable the
initialization of the
complete ink system.
Install the ink cartridges
as shown in the Setup
Instructions that came
with your printer.
file:///C|/Documents%20and%20Settings/---/Desktop/HP/html/p0151.htm (6 of 8) [8/5/2002 4:23:08 PM]
To Next Page
Loading...