To make sure you have the right wall socket outlets (wall receptacles) ready for installation, check the
following:
1. The wall socket outlets must be suitable for printer input ratings. See
Single phase power
on page 4.
2. The wall socket outlets must be suitable for the power cord plug type used in the country of
installation.
Table 2-6 60 inch printer power cord specifications on page 6 and Table 2-7 42 inch
printer power cord specifications on page 6 list several examples of the power cords and the
plugs provided with the printer according to the country. To make sure you have the right wall
receptacle, find your country in the appropriate table and check the plug type.
WARNING! Use only use the power cord supplied by HP with the printer. Do not use a power
strip (relocatable power tap) to connect both power cords. Do not damage, cut or repair the power
cord. With a damaged power cord, there is risk of fire and electric shock. Always replace a damaged
power cord with an HP-approved power cord.
Table 2-6 60 inch printer power cord specifications
Country HP Part Number * Length Plug type Plug
USA, Canada, Mexico,
Japan, Philippines,
Thailand
8120-6893 14.8 ft (4.5 m) NEMA 6-20P, 240 V,
20A, non-locking
International 8120-6897 14.8 ft (4.5 m) IEC 60309, 240 V, 16
A, 2L+PE
International – other 8120-6895 14.8 ft (4.5 m) Stripped end
termination, 240 V, 1.5
mm² cross sectional
area
WARNING! A
qualified electrician
must attach a suitable
plug according to local
laws where the printer
is installed, and to the
printer's electrical
requirements.
* Alternative part numbers are valid with the same specifications and markings.
Table 2-7 42 inch printer power cord specifications
Country HP Part Number * Length Plug type Plug
Argentina 8121-0925 8.2 feet (2.5 m) IRAM 2073
Brazil 8121-1101 8.2 feet (2.5 m) NBR 14136
Chile, Uruguay 8121-0923 8.2 feet (2.5 m) CEI 23-50
6 Chapter 2 Site preparation requirements ENWW
Requirements
To Next Page
Loading...
