Load a roll onto the spindle
1. If your printer is a T520, open the roll cover.
2. Remove the spindle from the printer.
WARNING! Do not insert your fingers into the spindle supports during the removal process.
3. The spindle has a stop at each end to keep the roll in position. The blue stop can be removed to
mount a new roll; it slides along the spindle to hold rolls of different widths. Remove the blue
paper stop from the end of the spindle.
4. If the roll is long, rest the spindle horizontally on a table and load the roll on the table.
ENWW
Load a roll onto the spindle
33
To Next Page
Loading...