TIP: Autorotation is particularly useful when combined with the Minimize paper waste roll switching
option (see
Roll switching options on page 24).
To enable autorotation:
●
In the Windows driver dialog: select the Features tab, then Autorotate.
●
In the Mac OS Print dialog: go to the Finishing panel and select Autorotate.
●
On the Embedded Web Server's Submit Job page: select Advanced settings > Roll options >
Autorotate.
●
In the front panel: select the Setup menu icon
, then Job management > Autorotate.
NOTE: If autorotation is set from your computer, it overrides the setting in the front panel.
NOTE: The autorotate decision requires known job dimensions. Therefore, printing does not start until the
job has been completely processed, regardless of the When to Start Printing setting (see
Select when to
print a job in the queue on page 103); and, if you request Autorotate and Remove blank areas, only the
latter will be done.
TIP: Once the job is rendered and ready for reprints, autorotation may take a few minutes, depending on
job dimensions and resolution. To speed up autorotated reprints, send the job to render when the roll
configuration meets your planned scenario, and leave last-minute autorotation only to correct unexpected
changes in roll conditions. This applies to TIFF/JPEG/PS/PDF jobs only.
Print in gray shades
You can convert all colors in your image to shades of gray in the following ways:
●
In your application program: many programs provide this option.
●
In the Windows driver dialog: go to the Color tab and look at the Color Options section. Select Print in
Grayscale.
●
In the Mac OS X Print dialog: go to the Color Options panel and select Grayscale from the Mode drop-
down list.
●
On the Embedded Web Server's Submit Job page: select Color > Color/Grayscale > Print in grayscale.
ENWW Print in gray shades 85
To Next Page
Loading...