Electronics Module test
The purpose of this test is to diagnose a failure in the operation of the Formatter.
1. In the Service Tests submenu, scroll to Electronics Module Test and press OK.
2. A message appears on the Front Panel asking whether you would like to check the Formatter.
Press OK to continue with the test, or Cancel to exit.
3. The front panel displays the amount of memory installed. “Real memory size” is the real size
detected, and “Total memory size” shows the rounded memory size. Press OK to continue.
4. The front panel displays the name, type and size of all the partitions on the Hard Disk. Press OK to
continue.
5. The front panel displays the name, size and percentage used of the data and boot partitions on
the Hard Disk. Press OK to continue.
6. When the test is complete, OK is displayed on the front panel. Press OK to restart the printer.
Carriage Assembly test
The purpose of this test is to check the operation of the Carriage Assembly.
NOTE: If possible, always perform this test before replacing the Carriage Assembly. If this test
passes, do not replace the Carriage Assembly.
ENWW
Entering the Service Tests menu
95
To Next Page
Loading...