5. When the printer has restarted, the front panel asks you to open the Window and remove all the
Printheads.
6. When you have removed all the Printheads, the front panel asks you to install the Setup
Printheads.
7. When you have installed the Setup Printheads, the front panel displays the following message.
8. When you have closed the Printhead Cover and the Windows, the printer begins to purge the
tubes.
9. When the tubes have been purged, the front panel asks you to open the Window.
10. Check that all the Setup Printheads have some ink.
11. The front panel asks you to change the ink funnel and waste bottle, but you should ignore this
request. Continue the purge procedure, pressing OK to advance through the procedure, but
without changing any parts.
12. At the end of the procedure, the printer aligns the Printheads.
Reset Life Counters
The purpose of this Service Utility is to reset the internal life counters. There are two submenus that
allow you to:
●
Reset all the counters related to a Preventive Maintenance Kit (PMK).
●
Reset only the counters related to a specific replaced part.
NOTE: Always reset the life counter of a corresponding part only after replacing it.
112 Chapter 5 Service tests and utilities ENWW
To Next Page
Loading...