Prime Tubes
The purpose of this Service Utility is to prime the Tubes when the Ink Tubes are not new and they need
to be re-primed or automatic priming was not completed correctly.
NOTE: Make sure that new Ink Cartridges are installed or that the ink volume remaining in the Ink
Cartridges is below 88% before starting to prime the tubes. Otherwise, you will see a warning
message.
1. In the Service Utilities submenu, scroll to Prime Tubes and press OK.
2. If the Ink Cartridges are not suitable for priming, the following message will appear on the front
panel. Replace the installed Ink Cartridges with Ink Cartridges that are new or contain less than
88% of ink. Press any key to exit.
3. When the following message appears on the front panel, press OK to continue or Cancel to exit.
4. The front panel displays the following message, then restarts the purge process.
ENWW
Service utilities
111
To Next Page
Loading...