Perform the Turn Drive Roller utility as follows:
1. In the Service Utilities submenu, scroll to Turn Drive Roller and press OK.
2. The printer checks to see if paper is loaded. If paper is loaded, the front panel displays the
following message. Unload the paper and start again from the beginning.
3. The Drive Roller begins to turn slowly and the following message is displayed on the front panel.
4. Refer to the Cleaning Instructions Clean the Drive Roller and Overdrive on page 465.
5. Once you have finished cleaning the Drive Roller and the Overdrive, press the Cancel key to finish
the utility.
6. If the utility exits correctly, OK will be displayed on the front panel.
NOTE: Please remember to remove the piece of paper from the Window Sensor before closing
the Window, as it could damage the Window and the Sensor.
110 Chapter 5 Service tests and utilities ENWW
To Next Page
Loading...